新加坡六合彩开奖直播

Gas hydrates are ice-like solids in which large quantities of methane are trapped in a solid phase as a result of suitable pressure and temperature conditions in the presence of an excess supply of methane gas. They are a potential fuel source, possible greenhouse gas contributor, and a geohazard concern due to their potential effect on slope stability. Gas hydrates may cause sediment failures by releasing methane gas and water when they dissociate (melt), causing in situ sediment pore pressures to increase. The purpose of this study is to search for the presence of gas hydrate in an area of known sediment instability on the continental slope east of Nova Scotia (Verrill Canyon area), using a geophysical approach. This area displays several sediment failures, between 15 and 12 ka. Geotechnical infinite slope stability analysis has shown that the area is inherently statically stable and that excess pore pressures were necessary to effect failure. Increased pore pressure probably resulted from one or more of: ground accelerations due to earthquakes or isostatic readjustments following glaciation, shallow gas charging, dissociation of gas hydrates, or rapid sedimentation during glaciation and deglaciation. Dissociation of gas hydrate is one of the proposed potential mechanisms. A drop in sea level or increase in bottom water temperatures as during glaciation / deglaciation may cause dissociation of gas hydrate, which would free methane and water; causing an increase in pore pressure. The presence of failures and pockmarks near the theoretical minimum stable depth (500 metres below sea level) is indirect evidence of gas hydrate. Hydrates in some locations can be detected on seismic reflection profiles by the presence of a bottom simulating reflector, which probably corresponds to the acoustic impedance contrast at the transition between gas hydrate and free gas. Gas hydrate can also be detected by using wide-angle seismics (such as an ocean bottom seismometer, or OBS) to detect an unusually high velocity within the hydrate stability zone, or velocity inversion below the hydrate stability zone. Examination of 14 high resolution single channel seismic reflection lines in the study area has not revealed any BSRs. An OBS was deployed where gas hydrates are most likely to be present (850 metres below sea level). A velocity model was produced from the OBS data, that displays anomalously high velocities coincident with the theoretical gas hydrate stability zone. It is therefore proposed that gas hydrate is possibly present in the sediment, but there is no indication of an underlying free gas zone, because there is no evidence of anomalously low velocities. This implies that the sediment failures near 500 metres below sea level may have possibly been induced by increased pore pressure, at least partially resulting from the dissociation of gas hydrate.

Keywords:
Pages:
Supervisor: Keith Louden